Search results

This is for D3,5,6,7?

@SYLV9ST9R just a note, it was incredibly nice of you to share all this info. Thanks sir.

Grabbed some from the PedalPCB store last time he had some in. https://www.pedalpcb.com/product/mini-rotary-switch-2p4t/

Correct, I use ribbon cable from @StompBoxParts. https://www.stompboxparts.com/ribbon-cables/ The in and out wires on the Parentheses are actually run through the PCB and wire up at the top left and right of the PCB.

This is definitely a longterm goal of mine! Congrats man. Great work.

Supposedly OP07 is what the production run Rats use now. I've used both and liked both.

I knew what you meant Bc it’s called the Mastodon through GuitarPCB. Built one and it was very heavy.

That Zvex Mastodon is wild!

I’ve had this board for a while and I finally got around to making it. Decided to go with the blacked out theme with a nice Gorva enclosure and black knobs/stamps. I didn’t have 2n3903s so I did some searching and found that the 2222As sounded good, so that’s what you’re hearing here. Also...

I typed it all in Affinity Designer and just uploaded the graphic to the website loader. I think I made my lettering 4mm tall.

The UberFuzz applies an octave up already. You could always try doing a splitter, one side into UberFuzz, the other side into an Ocelot Octave in parallel, and then combine their outs into the Muff. Out of the Muff into the Rat. Then you could basically just mix to taste. That would be epic.

Do I need to do anything where it says "disconnect here". I saw in his original post that he actually cut through the PCB trace there.

Thank you for doing that for us!

You're a golden god! I'll try this out.

Another positive note is that this forced me to do my first ever stripboard/perfboard build of that Tillman preamp and it worked! So that's cool.

All good. Thank you for trying to help! @Mir9 has a potential solution for me if he did his with the Promethium.

Could the “resistor” in question be the blend knob itself? That’s wired between input and output to pass the clean signal directly to the output. The Buff N Blend was wired: Input Jack to Input on BNB. Send on BNB to input of Promethium. Out on Promethium to Return on BNB. BNB out to output Jack.

The current version I have is wired exactly as Chuck mentioned above. So with a 3PDT board it works as follows: Input Jack to Input Jack pad on 3PDT board. In on 3PDT board to In on Promethium PCB. Out on Promethium PCB to leg 3 on blend pot. Leg 2 on blend pot to Out on 3PDT board. Output...

Rad! Did you do the mod on the Promethium board? And if so, where did you dip into and out of the circuit?

Hey Chuck, Tried both the 1uF Film cap as well as a Tillman buffer/preamp (I read that was a good basic buffer), and I still get the oscillation at the highest volume setting with both. If I roll back the volume like 10% the issue goes away. Again, this isn't an issue if I don't try to do a...