Search results

I was able to get it working perfectly by removing the 22p cap (C3). I believe this cap is being used as a method of debouncing the switch. I am not sure why this fixed it but it worked for my breadboard test and in the pedal circuit on the intelligent relay bypass pcb. It turns on or off...

I recreated the circuit on a breadboard (minus the audio input/outputs and ctrl transistor and r3) using the same Panasonic latching relay, ATtiny25V and new 5V regulator (just in case). The switching sometimes works instantly but then it reverts back to needing to hold the switch down. The...

I used a DPDT switch to change between stock Hydra clock and the FV-1 clock module as per the schematic below. I soldered the original X1 crystal and C7 cap on a separate board and have wires running to both X1 pads on the hydra pcb (connecting to FV-1 pins 9 and 10).

Was there a reason you chose B50k for the feedback pot instead of C50k? Also did you use for your trimmer pot in the distortion circuit? I ask because I am finding I cant limit the distortion enough. Once I switch it on, the signal is heavily distorted and the B5k pot doesn't do much to lower...

I haven't found any bridges connections. Everything is connected as per the schematic. One question I have is the microcontroller that came with my pcb is the ATtiny25V. It looks like it is supposed to be a ATtiny85V. Could this make any difference? As far as I can tell the 25 just has less...

When i hold the footswitch down the led blinks 3 times.

I will check this evening, I haven't installed the led yet

Does anyone know why i have to hold the momentary footswitch down for ~2-3 seconds to get the relay to turn on and off the effect? Shouldn't it turn on and off almost instantly? When i quickly depress the footswitch nothing happens at all. When i depress the switch and hold for 2-3 seconds i...

I thought half wave and asymmetrical clipping might be cool to try so i don't mind the individual switches. I thought about trying to mount the dip switch flush to the outside of the case like chase bliss pedals but I don't have the space for it so ill probably keep it inside the case. This...

Thanks! I will watch out for those LEDs!

It's one I am designing on a perf board. I will be wiring it to the je t'aime pcb in place of the diodes. I had a hunch I only needed one wire but wasn't sure. Thanks!

Can anyone comment on whether or not this should work as I have intended? Instead of placing D1 and D2 clipping diodes in the circuit I route them to another pcb with a DIP10 switch to add remove 5 pairs of clipping diodes into the Je T'aime circuit, or to mix and match diode pairs.

Found the answer to my pre/post repeats pot questions from another thread.

Can anyone comment on whether or not I am replicating what the OP is talking about in the attached schematic? Should the Electra distortion circuit be inserted before or after the C50k repeats pot?(edit-answer found, see below) I also added a DPDT switch to enabled/disable this mod. Any...