Search results

Well, it depends... Vero is easier to build, no need to create all of the tracks. On the other hand, with perf it's easier to follow the schematic and check correspondence in the layout

I made a quick breadboard to check voltages, I had 5v on the output so I put together the circuit on perfboard and wired it up It works surprisingly well! Here it is in all its glory!

My first DIY attempts were with perf, I still have a little one knob fuzz I built following Effectslayout page, then a Speaker Cranker and a Fuzz factory which is a mess of spaghetti wiring 😅

bit of a raw drawing but here's my idea any obvious fault in this? except for the danger of plugging it where it shouldn't be plugged, of course

Yeah definitely! Not for complicated stuff but it's great for throwing together a circuit you want to try out

I looked for a suitable font for a long time to recreate the logo, and as usual the forum came to the rescue! Thanks to @temol

It's a clear inkjet waterslide, you can see the purple is a little transparent

Oh my what a fuzz! I love starving the bias and getting a nasty fuzzy overdrive For the artwork I used "regular" names for the controls and went for a vintage DOD look, but it's a dud... One of my best looking waterslides so far

My first vero build is a slightly modded KMA Fuzzly Bear. I used a 250kA pot for the Sag control (idea stolen from @bean Fuzzy Britches) giving the pedal many more sounds, from super fuzzy, through a very prominent octave down, to gated-almost-non-working. I love it! I had to use some parallel...

As much as I am a music lover, I am quite ashamed to say that I've never paid attention to the Beach Boys, as a teen I put them in the "silly surf music" category and they stayed there. So I am now going to educate myself and experience Pet Sounds for the first time. Looking forward to it.

Hi guys I'm working on a noise box for my drummer. The idea is a Moon Cyberpunk (atari punk console) into an overdrive, into a simple delay capable of oscillating (a Crap Fi delay), with the option of switching the input of the drive/delay section with a jack in, to be able to put maybe a...

Why did you delete the thread? I had only read page 1 😭 🤣

Thanks a lot!

Yeah it's not too bad, but unfortunately not good enough to have scales around the knobs which I had in the original design

Please ignore the white washer that hides the too big and off center hole for the footswitch... Great little tone sweetener, I've mostly used it on the end of my effects chain and it's one of those effects you only notice when you turn it off. Not a lot of boost but great tone shaping I botched...

I just wish my drilling was as centered...

Thanks! I like the design but the waterslide isn't perfect, you can see the logos at the top and the text at the bottom are "leaking" red ink I need to find a solution for that, I read it could be the printer using RGB for black, or too much clear coating