Search results

Some kind of hornets nest I snapped while I was in Cancun. If you can't tell I zoomed in.. wasn't going near that thing. I didn't want to get impregnated by an Xenomorph. :)

I get my magnet wire for my pickups and my hook-up wire from Remington Industries

Nice. I have to finish mine... just deciding if I want high gain or not.

I got one of those and I ended up letting the smoke out. I even printed a nice cover for it and that melted a little..... too much power over a fairly long period and I lost :)

I tried this one, but realized that I F*** it up after I solder all the resistors on and so now it's been sitting my "junk" box for the past 3 years.

Use to do a lot of work at the airport. One of my amps was built by a person who lived out in Irmo, unfortunately he passed away. We grab dinner at Lizzard's Thickets in Irmo and then drink a few cold ones at his house. Check out his work bench of amps and would jam a little. good times...

The picture was taken in Columbia, South Carolina at Cayce Riverwalk (runs along the Conagree Creek), killing time after my son's graduation from Army Basic.

Nice... I finally finished mine yesterday after 5 months of sitting on it. Plus I solder it before installing in the case (before knowing not to do so). I went ended up with a bigger enclosure.

I know that a few members here have one. Not sure how it works on pedals.

Too lazy to repost everything ;) https://forum.pedalpcb.com/threads/vendor-list-thread.6569/ https://forum.pedalpcb.com/threads/a-few-websites-and-youtubers-that-deal-with-electronics.6119/

Was lazy with the graphics was going to call it "taste the juice", base on a Howard Stern drop. Change my mind, kind of kept it. Absolutely love this pedal. Drop is here

I have a Orange CrushRT20 which I absolutely love on the clean. I also have a HK Tubemeister 18 and a Egnator MK20. I'm thinking about selling my MK20 and getting a Orange, but before I do that. I would like to know if I can get the same on my HK via a pedal.

Could you please put this information on the "Additional Information" section of the PCB. Because I'm pretty sure that someone might not have done it in that order and butchered an enclosure.

I have a Fluke 189 that I can measure Conductance, but never used it and let alone when to use it.

Could you use the CONDUCTANCE function on a DMM?

I use mine one side is for my fuzz's, the second is just bypass my fuzz's.

Mine was Octagon MultiFX or could have been the Van Pelt which I ordered/built at the same time (2018). During my build on the Octagon I was thought it should have had a rotary switch instead of the pot. Of course the updated version did, but being lazy I haven't updated my build with the...

I have this Signal Generator at the time getting a new scope and this was a little less expensive of getting a built in wave. Of course once I purchased my stuff Hantek releases these models :)...

This is the C10 Model, but he said there isn't a wave gen on this model. It does look like it has one though.