Search results

Ok, I see. I must have missed that. Any ideas why the presence switch isn't doing anything either?

Yep! The reason I think they're switched around is because neither control works like it's supposed to

Are the switches for the contour and presence mislabeled on the circuit board? My presence switch doesn't seem to do anything and the contour switch just sounds weird... Any help from those who are more familiar with how the circuit boards are laid out would be appreciated!

I'm building a Cross Contaminator and I'm wonder what I could substitute for the 2N1711 germaniums because they're quite expensive. Any thoughts? Thanks!

Thanks! I'm just looking to cut a little bass out, because it is indeed a little bass heavy.

Check out the schematic for the BYOC Big Muff Clone, it adds a switch for the tone control bypass. largebeaverramsinstructions (byocelectronics.com)

Hey guys, I'm looking to add a switch for some different bass response values to my ODR1 clone. Which cap(s) control the bass in the Nobleman? Thanks!

Awesome, thanks!

I think it would be really cool to put a VU meter in a pedal. Does anyone know how I might go about wiring one up?

Yessir!

Swapped out the chip and it works perfectly! Thanks!!

I messed with them both and got it where I want it. Thanks!

Cleaned the board, still squealing. I'll try one of those new chips! What is it about the chip that might cause squealing when hooked up to other pedals?

I got it from Tayda. I will clean off the solder side and see what happens.

Update: Hooked it up to a battery and put it on my board and the same thing happened.

So I went through and took the transistors off and re-soldered them and added a low pass filter to the output jack and that fixed the super high frequency ring. Still getting that squeal when hooked up to the daisy chain, and I figured out that it only happens when hooked up to other pedals. I...

Update: I figured out it's only when I have the power connected to the daisy chain with the rest of my pedals. It's fine when I connect the 1-Spot directly into it. It goes away if I turn the gain all the way down but right as soon as a nudge it up to about 8:00 it starts again and doesn't get...

Thanks, got it! One more question: I had to change an electrolytic and now there's a high pitched squeal... did I fry that capacitor? What else could cause that noise?

Nevermind, I figured it out! Pinout was wrong. Thanks!

Found the diagram for it. Base Collector Emitter now... how do I know which leg goes where on the PCB? I tried following the schematic and I still got nothin'.