Search results

I guess my real question then is what are each of the S1-S6 analogous to? (which is ground, in/out, and SW)

Ok, So my input wiring comes from the switch side not the in/out on the board(Me to me: duh idiot the input and output are hooked to the jacks on the auditorium). But there are 4 terminals and 6 wires on the Kliche on the switch side. Do I need to double some up?

Couldn't get my images to load here is an IMGUR link to host the pics online.

So at this point I'm not sure if I am connecting wires correctly as things aren't labeled on the pcb as the auditorium (pics below). especially with the switch wiring as the pcb is numbered, no sw/gr/in/out on this Kliche drive. What I know: 1. when the auditorium is not plugged into power the...

Thanks everyone all the tips were very helpful. I had to do a combination of things to get it done but it is salvaged!

Thank you. I will try adding more solder to get the sucker I have to work, and invest in a better one in the future. Thank you

Welp fellas. The noobie made his first real f*** up today. I read somewhere that if you're putting in diodes you should use a socket, because the heat could damage them. Well the particular diodes (1N4001 Rectifier diode) going into my first kliche drive build didn't fit inside the sockets(now I...

Sweet! I figured but want to double check. I am a newbie to the electronics side of guitar playing and didn't want to assume. Thanks guys!

Hi all I was just wondering, I can't find 510k 1/4w resistors. 511 is close. Can I put those in place and have a functioning pedal? I know technically any changed value will effect the signal (even if only imperceptibly), but I'm not gonna fry anything will I?