Search results

THIS RULES. Thank you so very much. I will report back.

Thanks so much for this diagram! There is continuity through all of these points, as well as on the third leg of the level two pot. I also was able to probe audio through all of these points. Does that mean the damaged trace/broken connection is after that point?

Thanks @music6000! This is super helpful. I’ll test this in a minute.

Sorry I think I articulated poorly above that I tried c11 and R14 again and they seemed ok, I was getting audio off both.

I haven’t removed anything, the only thing I reoriented was the OC71 but that was socketed thankfully! I did reflow everything, so I may have overheated a trace. But I have no idea where to begin if that’s the case!

Ok! Made a little more progress here. So I checked continuity and values on all of the above. All seemed ok and correct. I then ran a bridge wire between leg 3 of the “level 2” pot to the out of the foot switch (is this bypassing anything??) It was then sounding super sputtery, so I re-seated...

I’m away from home but I will try tomorrow! Thanks so much, excited to see the outcome

R14 has faint but perceivable audio, C11 is fine too

Hi yeh I did! All seems ok, audio is passing. Any other areas of interest?

I’m not getting any audio when probing any legs of the Ty-141p. Should this be the case?

Also should I have the gain turned down? I have had all the pots maxed out when probing.

Probed that zone, it all seems ok! Signal is making it to the level two pot but not the output. I ran a wire from the middle leg of the level 2 pot to the out pad on the foot switch Pcb. Is this bypassing anything? Now I have signal passing through the pedal, but it’s super weak/quiet and kind...

Ok all here is where I’m at everyone. I can probe audio right through the circuit till I hit R13. It becomes very weak on R14 and I get nothing from the TY-141P on any pin. I’ve checked those particular resistors (r14/15) and they’re the right values. Could a trace be damaged/should I try...

I can probe a signal till it hits the TY-141, where it get really really weak. I also replaced the main foot switch just to be sure with no perceptible change.

Thanks! Switched that and now I get functionality with something with high output like a synth. All pots have an effect when used this way. However, signal is verrrrrrry weak with a guitar (this is with all trimmers and pots maxed).

Hello all! I am once again asking for some guidance on an almost functional build (pics attached). This one came together cleanly and I was really confident it’d just work 😭. I’ve reflowed all solder points and double checked components. I assume the dot on the OC71 is meant to match with the...

Yes sure did!

I’m officially stuck! I feel that this one may be bound for the shelf of despair

Got them from Mouser, should I order and try different ones?

Tried that, to no avail! joints are all looking good visually