Search results

So now I have another project that I almost trashed because I couldn’t figure out the problem, now I know. I bet I can get that other project working. Wow, lesson learned; never get ic’s from eBay.

Problem solved! I just got the chip from Digikey and this Kliche sounds like a klone. Tons of volume and headroom, super quiet, no trace of oscillation. I notice that the bad chips had no little indentation on the top left. Here is the beautiful and perfectly working chip. 😃

Exactly!! I cannot thank you enough for the help. I’ll let you know ASAP, Cheers.

You know, I have another pedal I was building a few months ago that I gave up on for the same reason, the charge pump came from the same batch. Now I’m thinking that I did in fact get a fake batch of chips. And it looking at the photo you provided I see that my chip is a lot different in fact it...

I will be getting my hands on some. Thank you

Yes it does.

Yes the diodes make no difference with this issue until I fix this issue, Diodes aren’t necessary.

Here is a pic. Thank you for the tip. I just ordered the same part from digikey. Hopefully that will do the trick.

I think I might have gotten them from eBay. Is there a way to determine if I got counterfeit chips?

Hello, this is my first time doing a pedal pcb version of this pedal. I have built a few Klone’s before. I also know that this design oscillates when knobs are all the way up however, in this case the oscillation starts the minute clicked on and continues AFTER it is switched off. You can slow...

I’m just about finished building the protoboard. I have just the single row strip to solder but I’m hesitating because the photos look to me like it’s supposed to be a female part there.

All resistor vales are where they need to be, the grounding wire is a little fryed but looks worse than it is, I checked that. All grounding is good. This is really unfortunate because I can hear some good tones coming from this.

Hello, I am building a Bullrush overdrive and I seem to be getting oscillation that only goes away when the gain or level are less than 11 o clock. I changed the routing of the input wire to footswitch and that seemed to help but its still a problem. I have built more than my share of overdrive...

Hello, I apologize if this has been covered elsewhere here. I have built a few really amazing TS variants from this site and normally use the standard breakout board however, I wanted to try taking advantage of the fact that these designs all have buffers on either end. So I have the new...

yes OH OK GREAT! Thank You

I apologize if this is a question which has been asked, i just purchased some breakout boards and am wondering about the two pads on the bottom end. one looks to go to switch and the other to pin 2. Also, i see 2 unlabeled pads on either side of the 4 labeled ones, are these grounds? thanks.