Search results

What power jacks fit the pre-drilled tayda enclosure size as it comes? I have to drill out the power jack hole on the enclosure to make the jacks that I have fit. Is there a jack that fits that size without manipulation?

Yup. Wrong value. Thanks for the help! This forum is amazing!

ill just wire them to the pcb. Thank you!! Now, to figure out why it sounds like absolute ass. Super fizzy, no sustain, and only responds to really aggressive pick attacks, and then, just barely.

What would cause a pedal to have the effect active when LED is not on, but bypass when switch turns LED on? LED wired wrong?

Final update- rewired off board wiring with solid core, jumped the extra LED pad, and all is good! When I replaced the CLR, i had a short from too much solder touching the next resistor, so that was where the not turning off issue was. Apparently you do need to jump the LED of using a 3dpt with...

Quick update-I rewired jacks, plugged in, and the LED came on….and wouldn’t turn off. Everything else worked, so progress? I DID jump the extra LED pad, and then cut the jump, because I thought that might be the reason the LED didn’t turn off. Nope, that wasn’t it. Still on. Removed the SW wire...

Temporary update-replaced resistor, reboxed, and no not even a sound now, not even bypass. Also, my solder sucker tip came off, shooting the spring across my workshop. Spent 30 minutes looking for it, then went to bed. Will try again tonight. My though is moving 24 gauge wire too much breaks...

Oh, wow. I should zoom in on my photos! I know thats the LED clr resistor, and was considering replacing just to rule it out as an issue. Looks like that might be the problem! Ill keep you posted

Hello all- Built a dream fuzz today, and forst tey everything worked…except for the LED. I used a 3pdt breakout board with LED. It didnt work, so I wired it to the motherboard spot, still doesnt work. Swapped the polarity just in case, and still no go. The LED works, tested on my multimeter. Do...