Search results

I spent a couple of hours yesterday doing the same thing, salvaged everything from a Guitar mania PCB, even sockets, using my Engineer solder pump

Did you end up getting it? My wife is looking at a xtool D1 I think, so I could actually put some artwork on my pedals 😅

I'll take another look inside Even without powering the circuit? I want to check with my little practice amp and with a buffer upfront Quick question, the diode I added on the 9v is protecting the polarity but on the + instead of the ground right? Yeah looking at the layout and at the schem...

Thanks, it works but... If I leave it plugged in with no power and activate it, for some reason some signal passes through, and it sounds like a very voltage starved distortion... Where is power coming from if it's not connected? Through the guitar cables?

It does go to ground I'm following this Effectslayout schematic: So I could add a 1n914 between +9v and the + of the DC jack?

I was trying to desolder components from my old Speaker Cranker perfboard build and I broke the 1n4001 polarity protection diode in half I only have 1n914s at the moment, can I use one of those? Or can I just jumper it since I will be using it with my power supply?

I just saw the Collector/emitter demo... Dang that's a good sounding muff 🤤

I too am always looking for something like this, especially for new circuits. I was looking for a Big Muff with mids control to maybe replace my Deluxe Sovtek BM and if it wasn't for it being mentioned in this thread, I wouldn't know that PCB was one

Yes I definitely need a better one, this one can't even check for continuity It does measure HFE though

Thanks, I did look into one of those but I didn't know which way to start reading the strips (first time dealing with 0.4w resistors), and one of the red ones looked like purple to me under direct light. In the picture it looks red

My crappy multimeter only goes up to 2000k so I can't test if these are actually 2.2m resistors Is the colour code correct?

https://effectslayouts.blogspot.com/2016/06/one-knobber-project.html The One Knobber project from Effect Layouts, for perfboard builds. The webpage has a link to a PDF with different values for different versions ("ColorSound One-Knob, D*A*M Meathead and Dark Meathead, and a one-knob adaptation...

I am sure Klaus from musikding will send you the replacement, it might take a while to get an answer but so far I've only had good experience with musikding I bought a Sea Horse kit and it was missing some capacitors, I sent them an email and a week later I had them in the mail

I'm interested in these two mods since I just built my Sea Horse and I'm very happy with it, but I just wish the Rate knob had more ausable "slow" range. Would this rate mod help it? And the feedback mod is for sending the pedal into feedback or to limit the signal when in feedback? Because my...

I like DBA stuff and their identity I just wish the dude would accept baldness and shave it all off

ah yes thanks, got it. In the end I added it on the 3pdt but on the pcb would've been wiser I did try it when I first built it but it didn't change the pop unfortunately

That was it. Thanks a lot! I don't know why I didn't think about it, since it's the same thing I did to get rid of the pop in my EHX Bad Stone

do I have the V1 board? Should I just add a 10K resistor like this: or rather directly on the 3pdt like this:

Looks like this is it. When I play during band rehearsals it is fine, when I'm home it pops so I'm thinking it's my amp

I have the impression that they keep most of the stuff for the kits, like the BL3207 chips aren't available but kits with effects that use them are