Search results

I got UPS once from tayda about 5 years ago and got hit with a surprise bill weeks later

Digikey is significantly slower for me than mouser but they had what I needed

@Feral Feline I like side jacks for a couple pedals on the floor with no pedalboard. Top jacks if you've got a board's worth. @genXslacker nice build. you over delivered on this one

Very cool. I recently discovered that I like the HFD after I initially misunderstood it and then spending an unusually long time for me trying to dial it in

I tried out kicad a few years ago and sort of struggled with the workflow. Then I tried diptrace and found it more intuitive for me and easy to use. It was something like needing to assign footprints at the schematic level in kicad that didn't make sense the first time using a PCB design...

Deez

Wouldn't be the first time

Absolutely nothing would surprise me

You love to see it

.bought the wrong tactile switches 😕

Are you saying I should check out my parts express cart now?

I've just finished reading all three parts and learned a lot. How does one determine the linear region for a given transistor? thanks for sharing your knowledge here

Yoooooo those knobs are sick

Tight

Same

No comments? This is a cool build. Nice job getting all these functions together in a neat looking build. This rules

@analog_bham some other tips are make sure your glue is spread evenly on the whole face of the enclosure, and don't skimp on the squeegeeing step

My experience with the edges coming up is from cutting the film too close to the print. try leaving 2-3mm extra around your print and also not hanging off the face of the enclosure