Search results

I've done it with a two boosts and a rotary - A, B, or A->B. One footswitch for the whole thing but I suspect you want more functionality than that.

Thanks, the board is built and working fine.

Will an LM2936-3.3 be ok for the voltage regulator, as opposed to the L78L33? And can I use DT-38 for the crystal?

Gudday all, Building an Arachnid, but don't have enough 1n914... but I have a metric buttload of 1n4148. Are these ok to sub in for the 1n914. I wouldn't be asking if this was a dirt pedal, but there's 9 of them in the Arachnid... Thanks, Willy.

Is it worth putting the aggression switch to a footswitch, or is there a middle setting that's absolutely a must have?

It would seem fairly pointless to have them both with the same gain available.... but thinking about it you might just want to swap between eq settings...

I sold a few to get a second hand PRS Se. I've got more loaned out.

Gudday all, here's my Brown Betty build, named Brotherhood of Steel. I added a buffer because I couldn't get it to stop squealing, and had to wire a few of the pots offboard due to the layout required for dual channels. It took a bit of tinkering with the gain trimmer to get a good...

I've built a couple of Thermionics, a Brown Betty, and Madbean's one off BE-OD clone. I didn't really gel with any of them yet to be honest, but I've only really tried the Thermionic in a (cover) band situation. They seem a bit one trick to me, even though I did them with dual switchable gain...

Just want to say thanks for updating this. I was as confused as hell.

You send pin 13 of the FV-1 to ground, iirc. There's a 10k at the base of the eeprom that I socketed, ran to the switch, and back again. The switch goes to ground, or to the 10k back to the eeprom. It's 18mm, so a bit bigger I think. Here's the unfinished box.

They're these one from Jaycar (an Australian electronics store). https://www.jaycar.com.au/round-rocker-switch-red-actuator/p/SK0994 They work in this case because they're not particularly high so they don't foul anything when you step on a footswitch, but they are quite large in reality...

They access the default FV-1 programs instead of the eeprom patches on the outside two octagons.

This is my 3x Octagon build, using 3 custom eeproms to have a board each dedicated to reverb, delays, and effects. The reverb and effect boards have switches to access the onboard FV-1 patches. Bit of fun, I've since sold it. Possibly too many options for me...