Search results

I'm currently sourcing parts for the Electro-Vibe Mini and I'm confused about the headers. Looking at the specs for these, the combined male & female height of just the black plastic is around 11mm. From what I can tell, the 7371 bulb is nearly 16mm overall, with about half of that being the...

I guess it's been awhile since I've placed an order with Tayda. Today I noticed the low cost USPS shipping option was no longer available. I've always thought this was great if you didn't mind waiting about 10 days. I sent a message to them and this was their reply: Unfortunately because of...

I built a Twin Face earlier this year and put a bass cut control before the input as well. I got the idea from the OP, but found a decent article on it that helped me out. https://www.premierguitar.com/the-recording-guitarist-the-fabulous-focus-knob The article assumes the control is going on...

I believe they are out of the Arachnid boards. Not related to the FV-1s, but thanks! I needed an excuse to curb my spending anyway. 😂

Not a big order, but I figure the ElectroVibe Mini will keep me plenty busy sourcing the low profile components. I wanted to add an Octagon with FV-1 chip soldered in, but it's currently unavailable. Next time!;)

You are most welcome! Nice work! Doing color graphics on a white or cream colored enclosure is nice as well. I'm looking forward to doing more of these. On a side note, I recently used the film-free transfer sheets to make a coffee mug with a photo of our dog on it for my wife. Came out pretty...

Thanks, I used a hot hairdryer on high for 10 minutes (begin with low for first minute to be sure transfer sheet doesn’t move) at close range on the transfer sheet with very slow movement. After peeling the transfer film off and cleaning up, I put the pedal in the oven for about 30 minutes at...

Kliche Mini I built earlier this year using Sunnyscopa Film-Free Waterslide Decals. I got the idea from some other clones out there, plus the gold colored 125B enclosure looks like a gold brick. The "Archer" at the bottom is both a nod to my favorite electronics store as a kid and the archer on...

Good to know. Thanks for the tip!

I tried the Sunnyscopa film-free waterslide decals today on a powder coated pedal I got from Tayda. It was my first attempt at it and it came out pretty decent on the second try (I think I had too much glue and not enough heat the first time). Anyway, just wanted to chime in here to say there's...

Nice, clean build! I just built one a few weeks ago and at some point I should do a build report. I had the same issue with my status LEDs as you did; they did not line up with the holes on the template. I ended up putting some electrical tape on the LED leads and another strip where the wires...