Search results

So would send A in the diagram correlate with the Jack in ( I have PCBs on the 3PDT stomps) and return a with Jack out?

Thanks, that's perfect!

The 3PDT only fits in side ways, but I would prefer it this way so that if the toggle is to the left to left side of the pedal is first and the right is second in the signal chain. Is there a way to wire it by hand with out the order switcher PCB?

I got these diodes from StompBoxParts for a AionFX Refractor (Klone) build. The website says"Cathode bands may be either blue or blue/red" which is unclear. The red band appears to be under the glass and the blue/grey band on the surface so I'm inclined to go with the Gray/Blue bands, but I...

If you can please post some pictures of the board. It really helps with debugging.

I changed the plastic pickup trims from white to black (I think it looks better). They are the standard 58/15 S pickups If you haven't pulled the pots out, how do you know yours has different pots then mine? I got the guitar used, so there is a chance it has had work done, but as far as I can...

My mistake b500k volume and a500 tone

So if that is a cap between the volume and tone pots. What is the best would to preserver the high end when turning down the volume pot? I find I get very muddy if I turn the volume down. Should I substitute a different cap, add a second cap, move the position?

THe B500K is the volume pot.

Thanks, I'm delaying this because I realize I got the wrong cap! I meant to get a 220 pF cap (0.22 nF) but accidentally ordered a 2200 pF (22 nf) cap.

Based on what I see online, my thought is to solder it like this:

I've got my PRS SE Hollowbody 2 apart, ready to install the 22nF treble bleed cap but I'm not sure which legs of the pot to solder it to. The volume is an a500 pot and the tone is a B500 pot. Adidditional there is what appears to be a resistor between the volume and tone pots. TIA

Looks really cool, do you know which buffer this uses?

It's an analog octave pedal

Protoboard Micro too.

Chop Shop. So many people recommended the Chop Shop in my recent thread, that I figure I've got to build it!

Yes, this is what I was thinking of. That makes sense, thanks

What is the benefit of stripping he insulation?

I've seen a few build reports that use uninsulated wires to connect the 3PDT board to main board. It looks very clean and was curious what product people are using for that.

@Robert so does that mean if I use the C-buffer I would want to jumper over the input buffer on the C-buffer?