Search results

Can I ask about troubleshooting a build aside from pedal pcb?

I see 110 ohms, but my meter tells me 100, what would you say?

I use this for mycology, probably not appropriate for solder fumes! It has a hepa filter

I think I melted another pad, is it ok? It's because I had to desolder a misplaced resistor

Do I need to take caution will opening and handling components? Charge pumps inside.

the nkt 275 of coarse i cant use that, what is suitable, I'm not picky , not looking for unobtanium, thanks for any suggestions

this fuzz calls for an electrolytic capacitor for example, 1U 5mm. but does not specify the voltage . a quick google search tells me anywhere between 50 and 1kvolt? does this sound right ?

how many Adderall does it take or how many bags of gummies does it take while searching the internet for parts hunting, i find this part of the process very unpleasant normally i find a few pieces then get hung up somewhere then the hours pass by and i still don't complete the list for even a...

Messed up so used to practice with new ts 101 iron

so FINALLY after searching for the correct power source for my ts 101 i don't find it easy like i expected. my cheap 25w iron seems much more easy to use. I'm still trying to solder halfway decent with it. My very first time soldering with the cheap iron was much much neater this one is a mess i...

model ns -ac3000 ( this is the adapter i just purchased) input: 100-240v ac, 50/60 Hz, 1.5a max output: 3, 4.5, 5, 6, 7.5, 9, 12, 13.5, 15v 3000 mA max 19.5 24v 2000 mA max Is this sufficient power source for the iron, and what are the...

any good recommendations for barrel jack power supply for ts101?

obviously I'm not electronics guy buy i ordered a 100 n film cap and got this monster, what did i not specify in the description when ordering>

is it just me or is it very difficult to source film capacitors and they are much more expensive than any other components even transformers are much easier to source

so the pad is GONE but it goes straight to bias trim pot #4 , can i jump from here? (pad on right side)

i ordered a TS 101 iron. is this a step up from a 25w Weller? also 22awg or 24 awg stranded wire for lead wire? thanks!

3n3 is NOT the same value as a 33n film capacitor?

is 25w hot enough? also what is recommended size of iron tip for soldering pedal pcb?