Search results

Here's a dumb idea to bake your noodle with: It uses a 4pdt switch, a cap, and a resistor to make a simple switchable single pole passive low pass or high pass filter. Probably not much use but fun to think about. I haven't breadboarded it or anything, I was just doodlin'

I've been working on a dual pedal enclosure using two PedalPCB boards - in this case two Muroideas for a dual-rat pedal. I thought it might be cool to allow them to operate in a few different ways. I haven't breadboarded this up yet, but thought I'd post this here to discuss in case there are...

Just closed up this Dream Fuzz with a few mods. Absolutely love the grind of an op amp fuzz. I popped this thing into an old (eddystone, I think?) enclosure I got from a friend. The slightly smaller size was a bit of a squeeze with the mods, and I built it upside down cuz why not. I think the...

Taking a freshly built Cheesemonger fuzz pedal out for a spin in a mix to see how it works. So far I like it, but it does have a bit of a low output issue I think. Anybody mod these to address that? I'm pretty sure I got all the components right :unsure:... I'm slowly getting a little...

I know it's not a PedalPCB based project, but I just HAD to share with y'all. I made a Tayda EP Booster! I set a challenge for myself to try to squeeze it into a little 1590A enclosure, inspired of course by the fabulous Xotic EP Booster. I couldn't resist putting the biggest honkin' knob I...

Wampler's Gearbox pedal has the ability to insert an external loop between the two separate Tumnus and Pinnacle sides (or use it as a way to route each side independently for external switchers). I think that's pretty neato. Anybody ever do that with multi-effect DIY pedals here? Would that be a...

After getting a little help over in the General Questions forum I finished up this awesome pair of Tommy III's. I routed the internal symmetric/asymmetric switch to the outside on both and also added a Rullywow Serpent Boost to one of them just for something a little different. These things...

Hi all, I'm getting ready to make all the purchases I need to build a Tommy III. I'm new to pedal building where I need to source and specify all the components, but not new at all to soldering or building audio equipment from kits (where all the components are provided). I'm not entirely...