Search results

I swapped that cap with another 22uf, neither tested funny with a meter or my cheapo parts tester. All the parts in the LED circuit have been swapped at least once and from what I can tell with a multimeter, the circuit is intact. Beats the heck out of me where it’s messing up, but the LED is...

Thanks for responding and for the feedback. The LED was soldered into the correct anode and cathode pads previously. I burned the cathode pad at a point when I was trying my third LED (ran out of good ideas and started throwing crap at the wall, unfortunately). I've pasted a screen shot from...

I’ve swapped all parts in the LED circuit at least once. I think this will just have to be an always on LED.

When reading resistance from switch ground to the six pads that connect the two resistors and cap with meter set to read up to 6M ohms, I get an open circuit at all connections save for C21 cathode; reads .8ohm. Resistance from switch ground to LED anode is 1.78K ohms.

Hey, sorry the pics are running late, should be attached now. You’ll notice I burned the LED cathode pad, so that’s running direct to R54 under the board. I usually don’t use breakout boards, but did this time given it being included with the low tide pcb. Since the LED was behaving the same...

This one’s been fun chasing but could use some help at this point. Low tide seems to work fine, but indicator LED stays dimly lit in bypass. If pedal is in bypass and you plug in the 9v supply, the LED is first bright for a second and then settles into dimly lit. First thing I did was check...