Search results

Hey dude, I built the pedal with the 4n7 and it just sounded off, weak and lacking gain all around. Switched the 4n7 to 47nF like DigitalZombie suggested and pedal was brought to life

I thought about the multi delay chips offered here It would be nice to have a tap tempo delay that doesnt make me jump through hoops like that

PT2399s have 600ms of delay, the average delay time of a FV1 is what? 1 second?

OK so as you know, the FV1 delays use 100K pots and the taptation uses a digipot instead of a regular pot on the PT2399, which acts as a variable resistor. Is it possible to implement this into a FV1? Instead of programming each delay to have tap tempo

Actually there's another option: You are most likely using PNP Germaniums right? Well they are incredibly sensitive to heat. It happened to me too, I built a PNP Germ Fuzz Face and suddenly it sounded splatty and....crap, checked the voltages, pot vaules, tried a 500K bias pot and...

Hardy fucking harr

I use Nichicone electrolytic caps

I cant say for sure about that...all I know is I tried a LT1054 and it whined even worse, when I tried it I made sure to bypass the link between pins 1&8 though

Nope, I use a Strymon Ojai which is supposedly isolated and I only powered it up

So I built the Delegate and I tried TC1044SCPA and 7660SCPA which were both aquired from Digikey, but they both whine for some reason. They emit a high pitch sound, almost inaudible but quite annoying if noticed Anyone know a fix for this?

So its an incomplete block? Or do I just hook it up instead of a pot? Is there something that should go between the two? I am sorry for the barrage of questions I am just a total noob.

I thank you quite a lot for this...but sadly it doesnt tell me much, I am not too familiar with the source code itself

I tried hooking POT0 to the control input of the Tap Tempo block and the Tap Tempo out to the Delay Time of a Delay block and I get nothing, any ideas?

So I installed all the drivers, multiple versions of them in fact and still this error occurs. It is driving me nuts. I connected both the 9V power and the USB

As far as I know the only values that were different were the 2M2 voltage divider resistors for the last gain stage I will measure the voltages for the sources and report back

I saw the thread regarding the capacitor mods and will perform it, but I had another issue that was bothering me. The distortion sounds slightly unbiased, has anyone encountered such and issue? I tried several Jfets such as J201s, MPF4393(which I verified by building a Bohemia) and 2N5458s

well turns out i am stupid and didnt realize that the dev board didnt get power from the usb

Hey guys, I am still getting the error connecting message, the CH341(-1). I downloaded multiple versions and nothing.

No dude, you read wrong, its making the same noise plugged or not

Here's the deal, I did build the Brown Betty and I dont recall it being as noisy