Search results

2nd build working great thanks again! Out of paranoia I did insulate the legs in the top row of pots from the pot canisters on the bottom - that could have been my problem in the first build but can't confirm - this board is very tight and I noticed the pots I was using were precipitously...

Yes - i tested about 10 different 2399s including the one from this project in a working disaster transport clone and they all worked. Thank you - I’m just going to go very slow and hyper check every step - this one is for a dear friend and i need to get it working. I will post back when I...

And on the direction of the diodes D2 abd D3, do you follow the build doc or the screened indication on the PCB? I guess it clips the repeats a little if I look at the schematic.

THANK YOU SO MUCH FOR REVIEWING. I'm still astounded at this community's dedication to the craft. Those pots are soldered from the other side of the board and working - i will check the solder joints on those caps as you rightly point out but they look solid. I really appreciate the time...

Skinny 1 uF caps on the way. I use what’s in the drawer clearly 😂. Great seasick chorus and one repeat! Take two will be tidier.

I’m going to rebuild using different (skinnier) 1u capacitors which will be a tad more photogenic and if it happens again I’ll post. The fat (chiclet) film caps I have in there now would obscure any diagnosis. I really appreciate the reply and offer to help. I’d only post a pic for a laugh. The...

Very sorry I'm new to this forum - what was the solution (where it says "SOLVED")? I've quad checked every value and orientation, and I'm getting exactly the same issue of "one repeat" from last nights build. I saw a recommendation to use MLCC instead of Poly Film for the 1u values (that...