Search results

The Led related to the tone switch still doesn't work and I still find the sound is a bit weird when the tone switch is active. If someone has a clue ...

Ok, so I know why I have clean sound when vol at 0. When the blend is at min settings, the bypassed tone is active. When It's at max settings it's inactive. In this situation I get no sound when the vol is completely down which seems to be ok. I don't know if it's how the pedal should react...

I just tested it, here's the result. It seems to be ok ? They are about 0,35v each.

I have already tried reflowing the led's joints and also all of the tone switch joints.

I have already checked everything...I noticed the two 820 ohms resistor had a bad value (680 ohms). I changed them but the problems are still here .Could some 2n5088 brand has reversed pin ? also there is a small scratch on the pcb ( cf photo) could it be the problem ?

According to the value on the board, I don't think they are swapped.

I have made a Fender Blender but I think some things doesn't work the right way: It seems to work the way it should except : - the volume pot : When it's at 0, I still have sound like a clean tone. When I turn it it begin to sound louder but also with more gain. - The Led related to the tone...

Hi, is it an original circuit or is it supposed to be a clone of an existing pedal ?

Sure, I will put it in a box tomorrow !

I tried your mods for R2 and R7 and It's much better for me . I can have a channel with a bit more dirt ! Thank you for giving some of your time and for your patience !

Impossible : when I'm at max settings I get only 1,5 Ohms . Is it normal ? I changed the pot ( to put a C1k as you recommended) and it's the same. It's strange as the boost pot seems to work fine when I play. Anyway I tried to put it at noon ( roughly) and I have 250/300mv on Q6-S...

Thanks for the reply ! Yes but the fact is that the amp is already overdriven so .... Now I have, thank you ! With my strat It's Clean and with my Les Paul and gain at max settings I have a very slightly overdriven sound more like a boost. I have checked every resistors value and it's ok. The...

I've measured 17,6V so I should be ok.

I don't remember, I already had a 7660s so I put it instead of the LT1054. Could it be the problem ?

Thanks for the reply , I first tried to solder them the other way that the one you can see on my photo, but I had no sound at all. So I reversed it and now it works but I only have a clean tone If I don't engage the boost . I think it's an EBC version as it is written" 2n2222a 58 C" on it. I...

I have a problem with the pharmacist overdrive. Everything works fine except that the pedal is clean even with gain at max value. Someone would have a clue ? Here are some photos and voltage for the transistors and the charge pump. Thanks !

I put a 5n6 and it' working good for me. Thanks for helping me.

I've put a 1N5 in C18 but the presence pot is not working. The only other mod I did is remove C2. Someone would have a clue ?

Thanks for the quick replie ! I'll try that !

Hi, I removed C2 and C18 because I had the same problem ( the pedal was too dark). I' m really impressed by the result ! I sounds way better. The problem is the presence trimpot doesn't work anymore. Is it related to c18 in some way ?