Search results

I have just started the Mister Fuzz circuit. There is a note next to the jumper tabs..."Voltage Inverter Bypass" (See Build Doc). There is nothing in the doc! If I'm planning on using both the voltage regulator and the charge pump do I need to connect these or just ignore them? Thank You

Hi, I'm planning on building the Mammal circuit, and I want to put different diodes in. I'm assuming that the 1N4001s are one way on the toggle, and the 1N914s are the other. If I want to have say BAT41s for direction and red LEDs the other, do I just place them the same way as the "stock"...

Hi, Just wondering what the bias settings are for the Indiana builds? Tweed has 3, Deluxe has 4. Thank you,

Hi, I was just wondering which transistor / what voltage I use the trimmer for in this build? Thank you, Robert P.

Hi, Another question with regard to the Arkaim Fuzz. I get that there's a Bypass and a Heavy footswitch. To test the board after I build it, do I only need to hookup the Bypass (right as you're looking down on the board) side? Also, there are 5 hookup outs on the Heavy side. I use footswitch...

Hi, I really want to build the Decadence Preamp correctly. On the build guide front page it notes 35V for the 7 Electrolytic caps. I'm having a hard time finding 2U2s and 22Us in 35V. Is this just a minimum volts needed type of thing and one can use 50V, or do all caps need to be 35V in order...

Hi, What voltage do the trimmers on the End All Red OD need to be set at? I didn't see that in the build doc. Thank you

Hi, The Arkaim Fuzz uses BC338 transistors. Mouser carries 3 types that correlate to hFE amounts. BC338-16 (160), BC338-25 (250), and BC338-40 (400). Since the Mountainking Megalith sounds pretty grimey to me, I was planning on using BC338-40s. Just want to know if things are going to fire if I...

Hi, These are two separate questions for two different builds. Question 1 the Danube build: Can I use ANY 550 transistor? I have BC550B and BC550C. Question 2 the Death Cap build: I assume that D2 (3mm red LED) is the slot above the "Head" pot. It's not labeled on the build doc. Does this LED...