Search results

Yep the resistor was the wrong value. She works perfectly. Thanks for the help.

Nope made sure volume was up. And tried adjusting the pots but nothing. I’m scratching my head on this one. On a side note I built the same pedal using a new pcb and it works fine. Not sure what I did wrong on this one though.

Here is the DC plug.

Here is an image of the input and output jacks.

Having issues with this overdrive I just built. Not sure what the issue is. I gone back over the build plan and didn’t see anything out of the way. I have a clean bypass signal but when the pedal is engaged I have nothing. Any help or tips would be appreciated. Thanks.

Okay thank you for the info and the link.

Hello, Can someone explain what the 6 pins are at the upper portion of the board? They are not labeled and I’m not sure what goes there. Thanks in advance.

Well I’ve tested my transistors and went back over the circuit and still have no sound? What would be good voltages to check for?

I did find Q1 and Q4 had the wrong transistors in place. I had used MPSA13 instead of the MPSA18. I still have no sound on the pedal. I get bypass audio just fine and I get a boost signal when I activate the boost foot switch. ?????????? I’m kinda stumped.

i swapped them around and now I’m getting sound but it’s really fuzzy sounding. Any ideas?

I’m having an issue with a stockade pedal I recently finished. I get bypass sound but not when any of the foot switches are engaged. Any ideas or help would be much appreciated.

That 4n7 cap was the problem. I double checked my other values and everything else was correct. Thanks for the help eagle eyes.

Hello, I’m having an issue with a Dream Fuzz I just finished building. I have bypass signal when the pedal is not engaged but when the pedal is on I don’t have audio and im getting a loud squeal. I’ve tired the controls all the way down or off and im still getting a squeal. The controls seems to...

Awesome I guess I overlooked that when looking at the BOM.

Hello, I’m having trouble with this recent build. I have bypass signal. When pedal is engaged I have no output basically. But when I touch the solder side in the bottom right corner with my finger I have audio signal. I’ve looked at this a couple times but I’m not seeing an issue. Any ideas...

Yep this took care of the issue thank you.

yep this fixed it thanks.

I have an issue with a fairly simple pedal I have just finished. I have bypass signal but no audio when engaged. I have also included some images. Thanks in advance.

I found that I did have 2pm the JFETs that were outside the proper bias voltage. I replaced some resistors and adjusted my trim pots and all was good. Thanks for the help.

I have a question regarding a M800 pedal I’ve built. My pedal works but I have a sound issue I’m not sure about. Ive used MMBFJ201 jfets in my build and have tested them and they work. The issue I have is when gain on the pedal is rolled down it’s sounds more like a fuzz than a distortion. I’m...