Search results

I'll definitely give that a look, but I didn't explain clearly. The mix and volume pots both act as volumes. At min value for either pot, zero sound is produced (including the dry signal). When both pots have any value above min, the output is the clicky/buzzing nightmare. The more time goes...

I've hit a wee bit of a wall, but suspect I've ruined the FV1 unfortunately. Goodness only knows how, but an LT1054CP managed to get into my TL072 bin at some point in the past. When gathering the components for this build, I blindly grabbed a chip from the bin and didn't double-check it...

I think I found it, or at least something which doesn't seem right. I did some probing for components with shorts to ground, and right off the bat R1 shows no resistance. Pulled that component, figuring it was a bad/cooked resistor, and there's a dead short between the pads underneath. If the...

Did you end up getting to the bottom of this, mate? I have a sneaky suspicion that I'm in a similar boat with my build.

Hello folks, hopefully a simple situation for you to help with. I was debugging my Pythagoras build and noticed all the spots where there ought to be +3.3v were only showing +0.3v. So I start poking around the power regulation section and find the L78L33 is too hot to touch, which...seems not...

Ugh, found the problem. The filter pot was hosed. Replaced it with a 9mm alpha and the whole pedal has come alive 🤷🏼‍♂️🤦🏼‍♂️🤘🏻

Hello folks, I've recently finished a Gerkin build and it seems to be functioning correctly aside from being suuuuuper woofy. The tone is completely devoid of treble at all, way darker and more woofy than I would have predicted. It sounds like a mountain of blankets is over my amp! To get...