Search results

ok, thanks for the tips. much appreciated

Can anyone provide some input on the best way to increase treble in this circuit? thanks

perfect, thank you for the quick reply

Which pin on the rotary switch is position 1, and do the positions go clockwise or counter clockwise when looking at the front of the pedal? (opposite of board view shown here)

can I use regular electros for this build?

thanks for the info. I've tried setting it all over the dials. doesn't react the way I see it in Pete Thorn's demo video for the real Wave Cannon mkII. it works, just not how I was hoping.

ok, thanks. Just wanted to make sure it wasn't me. I checked all the component values

When I engage this switch, it doesn't seem to do anything until a note has been sustaining for awhile. I expected an instant change with the feedback loop and dramatic change in capacitance.

Never mind. I got my head out of my @ss and figured it out right after I wrote this. Thanks

What does this look like under the shrink tube? I’m not sure how the black ground wire to pin 1 on the dwell pot is connected. I’d like to try this low pass filter method too. Thanks

quick tip for when you accidentally fill a hole- heat it up and stick a toothpick into the hole. clears it easily

I thought the same about C8. I tried it just for the heck of it, fully expecting it to just affect the tone. happy accident I guess

C9 didn't have an affect on Presence at all. I went all the way up to 330nf. All it affected was volume. I ended up adjusting C8 to 100nf. This brought both Presence and Tone sweeps exactly where I wanted them. Well balanced for both single coils (American Strat with CS69 pickups) and...

ok, thanks. I'll give that a shot.

I've built the Crunch Captain (not deluxe) and it works fine. But the Presence control is unusable after about 10 o'clock on the pot (way too much for my taste). It's a B20k. Would a B10k give me a broader sweep? or maybe go to a A20k?

thanks!

thanks. I was hoping to know what they are before building it because I do the graphics in parallel so that the enclosure is ready when the build is done. and this build group is going to be 9 pedals

are the toggle switch positions from top to bottom just as they are listed on the Threeverb page? Top=Hypernova (modulated), Center=Glimmer (shimmer), Bottom=Radium Springs (spring)? and the top knobs are (from left to right) Dwell, Control2, Control3?

thanks everybody. I ended up using all of the suggestions and went "heavy" on them all. in place of the 2u2s, I went with 47u. and in place of C7 and C9, I went with 100n. It's now where I want it with my custom shop strat and wolfgangs. thanks for the help.

I just laid this circuit out on a breadboard and it has way too much treble. It looks like R9 and C10 are a low pass filter. If I increase C10 from 3n3 to 10n, I think it will lower the cutoff frequency by about half. Not sure how much this will help if the bass freqs are already cutoff...