Search results

I use Sparksfun stuff https://github.com/sparkfun/SparkFun-KiCad-Libraries it has a lot of switches in it.

About the Acrobat -> bump :-)

Hi Tomi, yes its working. I could cut the connetions to pin 2 and 3 of U5A as they are on the backside of the pcb but I really don't want to, only if some one tells me that it sounds dramatically different. R41 is 180K on my pcb. Only R16/17 is different from the BYOC schematic.

Finally

Crazy!! In a good way!

It‘s done! Had to go to reddit for Karma farming and try to fish for compliments :ROFLMAO: This time everything is on a separate pcb and in a big 1590X enclosure. Baja Reactor, Unicab and the TPA module each fit in a 125B. The headphone amp should fit perfectly in an 1590A. I used Kicad to...

Cool, let‘s build a club :) Oh wait this already is a club. The unsatisfiable builders.

Woops you are right. This is the first picture of the status after I soldered it. Before the first run. Transistor and IC not plugged in...

I did not use pcb spacers so the pcb is held by the pots and the switch. The pedal is for home use so I think that is ok.

As mentioned in the Wrecking Ball thread, now it is really finished. I went back and forth a with a few different resistor and cap values and went back to stock except for R15 for a better presence control. I bought the kit at musikding and a glow in the dark enclosure at Tayda. It took a while...

Ok I thought a solution would do it. Marked it.

It works. New installation, same DRC settings -> great

May I ask for a "mothers rotten vagina" muff?

YES! I alwys run the checks on the schematic and on the pcb multiple times before sending the files to jlcpcb. Solved my huge mind numbing problem https://forum.pedalpcb.com/threads/aion-redschift-madbean-kezuroukai24-selfmade-pcb-issues.25482/#post-324524 But I have to admit that I would have...

Solved, two not connected GND pads.

Another find.. Also in 9.0.2

But there isn‘t another error. I deleted all the ignored checks and the thermal relief check was the only one I ever added manually l. No error. Only when I remove the small plane. I will install the newest release later and recheck.

Hi lovers of the computer aided pcb design, let me tell you to never deactivate the nagging thermal relief check in Kicad!! You notice that the two GND pads only have a connection to the small area of the GND plane. I thought that Kicad tells me that there is no connection to the GND...

Well, it‘s the company name. I made it like this

Oops… My autocorrection didn‘t tell me that it‘s a mistake :ROFLMAO: I meant planning. It‘s a Facehugger Doom Bloom and I thought the ground circle makes sense in a practical and design kind of way. The pink resistor is so large because there was no smaller one available with the same size as...