3PDT PCB question

[spi]

Hi,

I have one of those 3pdt PCBs that has a place for the LED on it. The LED location happens to be on the opposite side of where I'd like to put it. I can run wires from LED to PCB, but if the PCB were flipped, I could just directly mount LED leads to the board.

My question, given the symmetry of a switch, it seems like I should be able to flip the PCB over and use it upside-down. Is there any issue I'm not thinking of though?

 

[fig]

Hi,

I have one of those 3pdt PCBs that has a place for the LED on it. The LED location happens to be on the opposite side of where I'd like to put it. I can run wires from LED to PCB, but if the PCB were flipped, I could just directly mount LED leads to the board.

My question, given the symmetry of a switch, it seems like I should be able to flip the PCB over and use it upside-down. Is there any issue I'm not thinking of though?

Hi spi, how's is goin?

That would depend on several factors, but it seems pretty drastic to accommodate an LED. . What board are you using?

Nevermind the above, I misread your post. You would have to reverse the wiring to and from the board.