Caesar Chorus Tone Pot?

ttf

New member
Hello folks, first post but I've been lurking around and getting lots of helpful info. I have already built a Caesar and am looking to build a second one with some mods. One of them would be a rate switch similar to how I've modded my TC Electronics Tailspin (using this procedure) so I think I have an idea how to implement that on the Caesar.

The other mod I'm planning would be a simple passive low-pass or tone knob. I find that sometimes I want to be able to tame the brightness of the chorus effect to be a little darker. Now I've read from this thread that R34 R17 and C8 form a low-pass filter - would this be a great place to start and figure out how to squeeze in a pot somewhere here?

My understanding is that there is more than one RC low pass filter in the circuit (based on the Electrosmash CE-2 analysis) and so I am not too sure which resistor and capacitor combo I should hook up to a breadboard to play around with.

Any insight is really appreciated, thanks in advance my masters!:D
 
Last edited:
If it were up to my i'd start right before the BLEND pot with the wet signal and try to squeeze a LP filter in there. R25 seems like a good place to start for me. Just my 2 cents, but I'm no modulation expert.
 
  • Like
Reactions: ttf
Back
Top