Anansi
New member
Really new to building pedals (just started the past few months) and I was hoping to get some answers regarding the Cleaver boost and the trimpots.
I'm confused with the through holes that are around the trimpot are. I thought that 3362p's only have 3 legs?
But from the board design I see 3 extra ones (2 underneath where the trimpot goes and 1 above it)
What is the red one for? Is that for using a voltmeter?
Also, do I need to find a 3362p that has 5 legs for these 2 (green) through holes? Or do I just ignore those?
To use the bias trimpots, do I have to bias each side to 9v?
Thank you very much for your answers!
I'm confused with the through holes that are around the trimpot are. I thought that 3362p's only have 3 legs?
But from the board design I see 3 extra ones (2 underneath where the trimpot goes and 1 above it)

What is the red one for? Is that for using a voltmeter?
Also, do I need to find a 3362p that has 5 legs for these 2 (green) through holes? Or do I just ignore those?
To use the bias trimpots, do I have to bias each side to 9v?
Thank you very much for your answers!