Coda Effects Black Sunn 3pdt wiring help

[angelrulax]

I´m just about to finish the build of a Coda Effects Black Sunn PCB. The 3pdt wiring looks a bit chaotic. Can I do it like PPCB board?

Thanks for your help.

 

[hamerfan]

I am sure you can use a ppcb breakout board if you wire the corresponding points, if that's your question. It won't make it tidier.
Where will place your LED?

 

[angelrulax]

Thanks for your reply. I finished the build yesterday and I tested with the PPCB wiring (I've got a homemade test board ready with that wiring) and it works OK. The only strange thing is that in the LED pads my multimeter reads 9V, luckly my intuition worked and I didn't soldered any LED.

About your question, I will buy a 1590BB enclosure to have more headroom.Thanks again.

 

[xconverge]

Thanks for your reply. I finished the build yesterday and I tested with the PPCB wiring (I've got a homemade test board ready with that wiring) and it works OK. The only strange thing is that in the LED pads my multimeter reads 9V, luckly my intuition worked and I didn't soldered any LED.

About your question, I will buy a 1590BB enclosure to have more headroom.Thanks again.

What value resistor do you have in the LDR slot

 

[angelrulax]

4.7k. Tomorrow I will do some tests.