KR Sound
Well-known member
Finally got around to converting this for my friend. It was pretty straightforward, and I ended up replacing every wire and jack. The wires were so skinny that they kept breaking on me and several were broken before I even got started – it was the main reason he wanted me to look at it to at least get it working. I went ahead and replaced both input and output jacks as they were worn out and corroded, and used a new 3PDT foot switch with the breakout board to make it a little easier instead of the original 2PDT. I replaced the LED with a brighter one and ended up running it straight from the power to the foot switch as I couldn’t get it to work off the board for whatever reason.
All in all, a couple hours and now he’s got a dependable HepCat to use.
Merry Xmas everyone!
After: not the most prettiest wiring, but it wasn’t that organized to begin with.
Here’s all the whack skinny wires and old parts:
Before:
All in all, a couple hours and now he’s got a dependable HepCat to use.
Merry Xmas everyone!
After: not the most prettiest wiring, but it wasn’t that organized to begin with.
Here’s all the whack skinny wires and old parts:
Before:
Last edited:
