1590XX Deadendfx Petty Tears

Audandash

Audandash

Well-known member
This has been verified with a catch. All the pots and switches are plotted correctly. The jacks and cv hole will have to be drilled by you once you receive the box to verify proper placement. It is possible they will be added in the future but at this time thats the only way this one can be done. This is a really tight fit. My original template was just a best guess based on the information available. Deadend did not supply drill locations for the jacks and cv.

Tayda Electronics Drill

Tayda Electronics Drill Designer for custom enclosures.
drill.taydakits.com drill.taydakits.com
 
Last edited:
Tried this template and it will not fit.
The input output holes are too wide apart (hitting the socket of Q5 and are too high, interfering with pcb - same goes for CV jack).
Otherwise, all the pot and toggle switch holes are precise and as intended.
Maybe better to do it in 1590X or take this template and remove/refine the input output and cv jack holes.
 
Sorry about that. So the best thing to do will be to take measurements off the enclosure with the actual board. Deadend didn't give any drill coordinates for the jacks so like I said they were a best guess. We can either remove the jacks all together from the drill template and folks will have to hand drill those or if you can get me measurements I can update the jacks on the template. Tayda doesn't offer the 1590x for drilling so all I can do is the 1590xx. With it being such a tight fit it may be best just to hand drill those jacks.
 
DamirBogdan39 said:
I agree removing the jack and CV holes would be the best approach. Most likely i would order one without them and hand drill it. I could give the measurements in that case
Click to expand...
I updated the link with the jacks removed and marked it as verified with the catch you have to drill the jacks. If you get good measurements off yours we can update the template to include them.
 
You must log in or register to reply here.
Back
Top