Design PCB to fit an enclosure and drill template holes

[ThePanda]

How is everyone designing PCBs to work with the standard holes in the drill templates?

Currently, using Kicad to design and wondering about the pcb layout.

I couldn't find any thread discussing this.

 

[ThePanda]

Are you talking about designing around the predrilled enclosure patterns?

Yes

 

[Passinwind]

How is everyone designing PCBs to work with the standard holes in the drill templates?

Currently, using Kicad to design and wondering about the pcb layout.

I couldn't find any thread discussing this.

You can make array grids as footprints to match the pot hole spacing, for starters. Treat them as templates and delete after you get the pot footprints correctly aligned on the hole centers.

 

[iamjackslackof]

I asked Robert about this, and here is his response.

 

[ThePanda]

I asked Robert about this, and here is his response.

That is exactly what I need.
I asked my friend and this is basically what he told me too.
Kicad has drawing layers you can make.

I also have to make a footprint for right angle pots.

 

[KR Sound]

That is exactly what I need.
I asked my friend and this is basically what he told me too.
Kicad has drawing layers you can make.

I also have to make a footprint for right angle pots.

I have some and the MadBean KiCad library if you want it.

 

[ThePanda]

I have some and the MadBean KiCad library if you want it.

Thank you! That would be awesome! I haven't been able to find the proper Kicad libraries.

 

[swyse]

I use EasyEDA and for mine I just put the pot footprint at the coordinates given for the predrilled pedalpcb enclosure I want to use from Tayda or whatever my custom drill set up is. In my case the pads are offset the appropriate distance from the footprints center point, but if your footprint isn't then you have to do the math, I'm not sure if KiCad has XY coordinates like this, but I've found this really convenient.

 

[Bio77]

You can also use the same process you use to add logos to PCB designs (plenty of tutorials on YT) to add your drill template to the design. That's what I've done in the past. I just eyeballed the pot placement from there and deleted the drill template when I was done.