Fist bump possible incorrect values

[OD is Glorious]

I think there might be an error somewhere because R4 is silkscreened on the board as 10K but the build documents and schematic say 1K. I also have a question about C6. I soldered in a 47U because I think that’s what was silk screened on the board but the build documents says 4U7.

I don’t think the pedal operates as it should. There is no unity. The punch and smooth knobs do very little. But the frequency knob is very aggressive going from treble and lower output all the way clockwise to very deep and loud all the way counterclockwise. Thanks so much.

 

[Robert]

1K is correct, it should have been blacked out on your board.

4u7 is correct and should be what is printed on your PCB, but 47u really won't cause any issues and isn't worth replacing.

It's still going to be painfully loud.

My understanding is that this is for boosting an already cranked up high gain amp. It's virtually useless through a clean amp like my Princeton, the volume starts at 11 and goes up from there.

 

[OD is Glorious]

1K is correct, it should have been blacked out on your board.

4u7 is correct and should be what is printed on your PCB, but 47u really won't cause any issues and isn't worth replacing.

It's still going to be painfully loud.

My understanding is that this is for boosting an already cranked up high gain amp. It's virtually useless through a clean amp like my Princeton, the volume starts at 11 and goes up from there.

Thanks. I clean every board with 99 iso prior to build so possibly wiped that off?
My fault. I have been just following the board values but when the controls were wonky here I started checking to see if I screwed up.