Robert

Phrasing?

I’ll admit that I built this a couple of weeks ago but I was hesitant to post about it here because, while this community is built on...

I forgot to say, that this Kaede has tons of lowend availabel on tap (also with the bass control at zero!) and it does wonders also with...

I discovered only now about this clone! I have the original Kaede and it's an amazing overdrive! The schematic confirms what I was...

Tried blu tak once, never again. Blue painters tape is definitely what you want. Seriously though, I've never used blue tak or...

A plugin compressor won't add its own hiss, but it will lift up any existing hiss in the source signal during the quieter passages...

It's a pretty popular pedal / circuit, that's way more noise than normal unless that amp is dimed.

Having looked at the schematic, I would expect quite a bit of hiss with so many TL07x coming one after the other. They're not the...

Correction, C9. I was looking at my trace schematic, not the final schematic in the build doc.

Nope, I think you got the right one.

It's getting some upgrades so might be a little while.

Install a jumper in place of R29. IN > FX In S6 > LED control (purple wire in the MIDI module pic above) OUT > FX Out

What software does that use?

Drop C9 down to 10nF and see if you like that better. I've traced two of these, one had 10nF in that spot which makes a little more...

That did it, thank you!! First successful build, very much appreciate the assist!