I´ve seen some discussions regarding this question so please forgive my ignorance.
Is there a “hardware” only solution to add a rate/tempo LED on the Hydra Delay? Just the LED, no tap-tempo stomp switch. In some threads these 2 things are often thematically mixed together.
I have schematics (like Hydra mono pedals) with the FV-1 where the unused Rout Pin 27 is used to drive a LED via a small BJT.
What I didn't fully understand:
Do I have to write an extra code on the FV-1 for this purpose or does the chip acts by default this way?
Thanks a lot.
regards
Is there a “hardware” only solution to add a rate/tempo LED on the Hydra Delay? Just the LED, no tap-tempo stomp switch. In some threads these 2 things are often thematically mixed together.
I have schematics (like Hydra mono pedals) with the FV-1 where the unused Rout Pin 27 is used to drive a LED via a small BJT.
What I didn't fully understand:
Do I have to write an extra code on the FV-1 for this purpose or does the chip acts by default this way?
Thanks a lot.
regards
