Cybercow
Well-known member
Anyone have any experience building out a DeadEndFX "Meta Morph" (Last Gasp Trans Room - Analog Modulation Reverb)? I have questions.
The first one being, with known workin MN3011 BBDs and known working MN3101 clock chip, how could I be getting the modulation but no reverb? It sounds more like a chorus or flanger than a modulated reverb. I've worked extensively with MN3011 BBDs and understand them. The build doc is attached below and project shots with a voltage measurements page too.
I've signal traced throughout and have signal in & out of the BBDs, but no reverb - just a swirly chorus/flangery effect. Any thoughts, feedback or other input is more than welcome.
Thanks!
[EDIT: added voltage measurement chart and the incorrectly oriented C2 has been corrected by wy of replacement. No changes with the C2 swap.]
The first one being, with known workin MN3011 BBDs and known working MN3101 clock chip, how could I be getting the modulation but no reverb? It sounds more like a chorus or flanger than a modulated reverb. I've worked extensively with MN3011 BBDs and understand them. The build doc is attached below and project shots with a voltage measurements page too.
I've signal traced throughout and have signal in & out of the BBDs, but no reverb - just a swirly chorus/flangery effect. Any thoughts, feedback or other input is more than welcome.
Thanks!
[EDIT: added voltage measurement chart and the incorrectly oriented C2 has been corrected by wy of replacement. No changes with the C2 swap.]
Last edited: