Mofeta cap value discrepancies

[Strepitus dirus]

Hello friends
I’m embarking on my first build and populating the board on the Mofeta preamp. I bought the components on the pick off sheet and am noticing that they don’t match a few labels on the board. See pics
C8 on the board has 220p printed on it and C20 has 100p printed on that location.
Would anyone know which values are correct?
Thanks

 

[Cybercow]

With the schematic not yet available, there's no clue where those caps are located in the circuit. I'd go with the printing on the PCB. That's the typical fall-back solution.

 

[Strepitus dirus]

Thanks I shall go with the values on the board. It’s been a bit of a challenge getting parts for this. I realized after I ordered the PCB that good quality 2N5457 fets are difficult to obtain unless I go with SMD. Luckily I found some Motorolas but had to pay a bit for them.
Also ran into a problem fitting the pcb in a 1590B enclosure so I procured a 1590C that fits.
Cheers

 

[vlad7329]

Has anyone checked the schematic from the builddoc?

I want to make my own board, but would appreciate verification on whether it works as intended