Ocelot Octave

BuddytheReow

Breadboard Baker
This one has been sitting inside an unfinished enclosure for some time. I was on vacation last week and unfortunately brought some COVID back with us. This is my first time getting COVID and you'd think after being pretty darned careful over the years the general population would learn their lesson. But, nooooooo. I figured this is a way to pass the time and just knock this one out. I decided to go with a PacMan theme because why not. Yes, it's a bit glitchy and doesn't track super well, but it's still a fun pedal to mess around with every once in a while. Not super thrilled with how this turned out, but oh well. There always the next pedal.

1685034329739.png 1685034345628.png
 
Hello
I have problem with the PCB and the pin2 (the gate) on the Q3 I lost the soldering connection
I tried as marked on the jpg to solder to the R20 and the R19 (blue and orange threads) but nothing changed and it still doesn’t work

Can you tell me please where the 3 pin are linked espacially ht epin2 the gate but if uou can also tell me if my schema is correct
can you test that with a multimeter..i wrote to pedalpsb but no one respond me
by advance thank you
1688655340085.png

I uploaded on my dropbox a video to show the problem on the attached files
here is the link https://www.dropbox.com/s/i7yxhjnf78myuqk/20230628_215748.mp4?dl=0
 
Hello
I have problem with the PCB and the pin2 (the gate) on the Q3 I lost the soldering connection
I tried as marked on the jpg to solder to the R20 and the R19 (blue and orange threads) but nothing changed and it still doesn’t work

Can you tell me please where the 3 pin are linked espacially ht epin2 the gate but if uou can also tell me if my schema is correct
can you test that with a multimeter..i wrote to pedalpsb but no one respond me
by advance thank you
View attachment 51888

I uploaded on my dropbox a video to show the problem on the attached files
here is the link https://www.dropbox.com/s/i7yxhjnf78myuqk/20230628_215748.mp4?dl=0
I would open up a troubleshooting thread with your question. You will get a better response from other people rather than a "Build Report".
 
As demanded on the jpg "ocelot Q3pin2" can you show me where i have to solder the pin 2 of the Q3 on which component ?
by advance, thank you
 

Attachments

  • ocelot  Q3 pin2.jpg
    ocelot Q3 pin2.jpg
    311.3 KB · Views: 5
Back
Top