SOLVED Parasite trouble

[innerlight]

Just popped together a parasite for a friend.
No signal when engaged!
Had to use some biiig 68n caps because it’s all I had.
Areas of interest- the pot may be wired wrong! It’s a 10k dual.
I’ve reflowed. Board is clean. Any ideas gang?
Thanks in advance, any help is appreciated.
If you can’t spot anything obvious I’ll start audio probing tomorrow.

 

[swyse]

Is it getting power to the board? I'm not sure, but I think the pin you're using for the board mounted power jack is for the switching part and not the barrel.

 

[innerlight]

You’re right! I corrected it, but still no signal

 

[innerlight]

Ok did another reflow, connected the power correctly and voila!
Marking this one as solved.
Just have to get the pot seated and buy some grease!
Thanks @swyse and thank you @Chuck D. Bones as always for answering my dumb questions.

 

[RetiredUnit1]

Ok did another reflow, connected the power correctly and voila!
Marking this one as solved.
Just have to get the pot seated and buy some grease!
Thanks @swyse and thank you @Chuck D. Bones as always for answering my dumb questions.

I'm just getting ready to start on mine, was making a list of stuff I needed when the doorbell rang, I answered it and found the bag of components I needed for it, that I ordered "slow ship" and totally forgot about. Took one look at the jacks and realized I ordered TS instead of TRS. sigh. And I did not even order the pot, so I guess I can get that when I order the TRS.

What type of pot do you have there? My wah enclosure specifies a splined shaft (but doesn't specify size in mm).