PedalPCB ChargePump with a competitor's PCB? LEDs??

[bassrep]

Happy Tuesday y'all! I have built up a project board from Hammond Toneworks that does not have led eyelets on the pcb. And neither does the PedalPCB Chargepump. (It's also NAKED on the website in terms of docs!) Can anyone give me some help in deciding where I can put an in/out led in this circuit? Thank you so much guys, you have been so helpful in the past.

Todd

 

[Robert]

You'll need a current limiting resistor, something like 4K7 for a standard brightness LED.

Connect one end of the resistor to the Fixed +9V pad, the other end of the resistor to the Anode of the LED, then connect the Cathode of the LED to the SW pad.