fydo
Well-known member
- Build Rating
- 5.00 star(s)
Hello!
I've been making pedals for a while so I figured I should probably starting putting my builds up here
Yesterday I finished this fun build. I followed this excellent mod guide for PedalPCB's Paragon (King of Tone) - https://forum.pedalpcb.com/threads/paragon-pcb-mods.10487/
The guide was very thorough and explained each step well.
This is the first pedal where I used Tayda's drilling and UV printing service and I have to say I am impressed! A friend of mine made a doodle of my little cat mascot (fydo), which I vectored up and applied it to ckaudioeffect's template.
I was pleasantly surprised to see it working perfectly the first time I fired it up (aside from forgetting that I left both volume pots at 0 at first, haha)
I am planning on upgrading the jacks to Lumbergs, as these cheap ones are the only ones I had on hand that would fit with the tight space.
So big thanks to both PedalPCB and ckaudioeffects!
I've been making pedals for a while so I figured I should probably starting putting my builds up here
Yesterday I finished this fun build. I followed this excellent mod guide for PedalPCB's Paragon (King of Tone) - https://forum.pedalpcb.com/threads/paragon-pcb-mods.10487/
The guide was very thorough and explained each step well.
This is the first pedal where I used Tayda's drilling and UV printing service and I have to say I am impressed! A friend of mine made a doodle of my little cat mascot (fydo), which I vectored up and applied it to ckaudioeffect's template.
I was pleasantly surprised to see it working perfectly the first time I fired it up (aside from forgetting that I left both volume pots at 0 at first, haha)
I am planning on upgrading the jacks to Lumbergs, as these cheap ones are the only ones I had on hand that would fit with the tight space.
So big thanks to both PedalPCB and ckaudioeffects!