Plaid overdrive possible issue found.

[jimilee]

I wasn’t getting any power to IC2 pin 8, no continuity and everything was where it’s supposed to be, plus it’s a straight shot from IC1 pin 8. Ran a jumper from IC1 to IC2, fixed it. These things happen during fabrication and usually only effects one or two boards. Happened to me in another non pedalpcb board. Just a heads up.

 

[fig]

I just checked my pcb, and have continuity from IC1-8 to IC2-8. Sorry you got a dud dude. I’d offer you this one but I’m sure our tallest has already vacuum-packed one.

 

[jimilee]

I just checked my pcb, and have continuity from IC1-8 to IC2-8. Sorry you got a dud dude. I’d offer you this one but I’m sure our tallest has already vacuum-packed one.

Thank you, I appreciate that. No worries, I jumpered it, it's all good. These things happen, like I was saying, probably won't find more than one or two, but just in case.