jimilee

Any wire will do the trick. I like cloth covered bc it looks neat, but your 22awg Teflon stuff will be 100% fine

Look where one of my JTEX Distillers ended up 😲 The pic is from a show just a few days ago.

You watched men in kilts with your wife?

Yes!! Such a dumb error but it made all the difference :) I am in awe of your sleuthing, Robert - thank you so much!!

And gone!

It never occurred to me to make a jig. And I still probably won't! I use the burnt finger approach and it works fine for me. The burns...

I had a request to give a basic primer on opamps. What does an opamp do? What's the difference between them? Why do builders use...

Even the Am Pros have fake wide range. They just recently reintroduced the CuNife pickups again.

If I thought I had a chance in heck of getting a recording that showed off the pedal rather than the lack of talent of the hairless ape...

Love this Design! Coming Soon PedalPCB Anvil Fuzz is Gilmour based pedal also.

Pretty sure your 3pdt board is upside down. You could most likely wire it 1-8, 2-7, 3-6..and so on. That would be easier than try to...

Put different resistors in parallel to see which works best, and then go with that value pot. A parallel calculator works best for this.