I'm trying to make ROG Splitter/JMK Blender into a parallel gain section (Scabbard 1st gain section + Punkifier Fuzz section) into 2 half of the Scabbard (Filter + 2nd OP07)
Does this even work electrically? Or this is design something even worth pursuing? (Would the voicing of each side be even suited for parallel?)
Let me know of any glaring errors in the schematic...
I tried isolating the op-amp building blocks (shown in the image below) but I am not sure if I am fully understanding what everything does... or if I isolated each "block" correctly for impedence matching etc
This my first attempt at drafting something somewhat "original" in KiCad also not much EE knowledge but willing to learn
Also, not 100% sure how to consolidate the two power sections
Do I chain them both into Vref?
EDIT: Nvm I have to change the blend because the TL071 will distort in an active mix with too much gain, will be back with update
Last edited:
