drew.spriggs
Well-known member
Howdy,
Planning a Sanguine, and as I hate painting I am going to get Tayda to drill/powder coat. I figure the hole spacings are gonna be in freedom units, so trying to convert over as best as I can.
Can somebody please confirm the coordinates I'm using? If I convert the drill guide to a SVG some of the holes are a bit off center/square if I align the center of the drawing to the center of a 125B model.
(Dimensions off of centre)
Pot holes row 1: -0.8/1.5", 0/1.5", 0.8/1.5" (all 7.2mm holes) - easy enough
Pot/switch holes row 2: -0.8/0.5", 0/0.5", -0.8/0.5" (7.2 outside, 6mm center) - easy enough
LED: 0/-27.3mm (?) 5mm hole
Stomp: 0/-45mm (meant to be 1.75"?) 12mm hole
Cheers
Planning a Sanguine, and as I hate painting I am going to get Tayda to drill/powder coat. I figure the hole spacings are gonna be in freedom units, so trying to convert over as best as I can.
Can somebody please confirm the coordinates I'm using? If I convert the drill guide to a SVG some of the holes are a bit off center/square if I align the center of the drawing to the center of a 125B model.
(Dimensions off of centre)
Pot holes row 1: -0.8/1.5", 0/1.5", 0.8/1.5" (all 7.2mm holes) - easy enough
Pot/switch holes row 2: -0.8/0.5", 0/0.5", -0.8/0.5" (7.2 outside, 6mm center) - easy enough
LED: 0/-27.3mm (?) 5mm hole
Stomp: 0/-45mm (meant to be 1.75"?) 12mm hole
Cheers