skrattadu Member Mar 21, 2022 #1 Hey guys, I'm looking to build a signal switcher... one signal in, three signals out via a single three-way toggle. How might I go about that? Thanks!
Hey guys, I'm looking to build a signal switcher... one signal in, three signals out via a single three-way toggle. How might I go about that? Thanks!
SYLV9ST9R Well-known member Mar 21, 2022 #2 You can find the Morley ABC schematic floating online, each signal on a switch, but might be a good starting point.
You can find the Morley ABC schematic floating online, each signal on a switch, but might be a good starting point.
Robert Reverse Engineer Mar 21, 2022 #3 DPDT ON/ON/ON as 3-way Switch - PedalPCB Wiki wiki.pedalpcb.com
skrattadu Member Mar 21, 2022 #4 So I got this from that diagram... any jumpers I need to wire in? Attachments 275101992_514830533498327_338417249414017230_n.jpg 55.3 KB · Views: 5
Robert Reverse Engineer Mar 21, 2022 #5 Yes, you need a jumper between either A2/B3 for a Type-1 switch, or A3/B2 for a Type-2 switch. This is the pinout of the switch (relative to the schematic above) looking at the lugs.
Yes, you need a jumper between either A2/B3 for a Type-1 switch, or A3/B2 for a Type-2 switch. This is the pinout of the switch (relative to the schematic above) looking at the lugs.
