I'm building the PedalPCB Tuner (PCB320, not Q-Tune). Two things the build doc doesn't cover:
1. Footswitch behavior — is it tap-to-toggle (press once to engage, again to bypass) or momentary/hold (hold to tune, release to bypass)? Is this configurable in firmware?
2. Standoff/spacer placement — the doc lists M3 female/male standoffs and screws by type and quantity but doesn't show which mounting points each goes to (board-to-board vs board-to-enclosure, etc). Would anyone be willing to post a couple of photos of the assembled hardware stack so I'm not guessing? Would save a lot of reverse-engineering time.
Thanks!
1. Footswitch behavior — is it tap-to-toggle (press once to engage, again to bypass) or momentary/hold (hold to tune, release to bypass)? Is this configurable in firmware?
2. Standoff/spacer placement — the doc lists M3 female/male standoffs and screws by type and quantity but doesn't show which mounting points each goes to (board-to-board vs board-to-enclosure, etc). Would anyone be willing to post a couple of photos of the assembled hardware stack so I'm not guessing? Would save a lot of reverse-engineering time.
Thanks!