Latest activity

Thanks! Weird about your volume - mine is at unity a little past nine o'clock. I think I read some other similar build reports where...

Another great looking build! I like mine, there is a perceived volume drop that I need to fix. Also, it would be great to be able to...

I was looking for a better way to hold enclosures steady while I sand them. “Better than holding them with my feet?!” you ask? Maybe so…...

In this part, we'll discuss what happens when we put a resistor in parallel with a pot. We'll address the simple case where we use the...

So how do know which taper to use? It really comes down to how the circuit responds when we turn the knob. For the most part, A-taper...

Check R44 if the ICs don't get power. Also, make sure it's 100 ohms and not 100k.

~4.5v at pin 1 with a load of some sort. If your circuit ends at pin 1, I'm not sure how the loading of your DMM would construe the...

I have to stay organized because I’m naturally unorganized and messy. I focus on the task at hand and move to the next step before...

Another great looking build! I like mine, there is a perceived volume drop that I need to fix. Also, it would be great to be able to...

As I said, once they are proven. First pass is just arriving this week so need to build and test, watch the github link as they will be...

I have to stay organized because I’m naturally unorganized and messy. I focus on the task at hand and move to the next step before...

The image is just the power section of a distortion pedal I’m building. I. Left out the larger schematic since there. Is no power up to...

I have never really been that big on vibrato ( except sometimes in modulated delays) it has always kind of embodied the operational end...

Detailed pictures of both sides of the board helps immensely when asking for help troubleshooting. I use it with single coils and it's...

Alright, so a couple things for starters: 1A @ 9V is plenty to get the tubes warmed up and the circuit running testing tubes with a DMM...