Latest activity

I get my ICs from mouser or direct from Texas Instruments... could just be a bad TL072... I will swap out.

These boards are small enough to fit in perfectly.. Thanks for the advice..

I googled it for you, first hit: https://www.hobby-hour.com/electronics/s/arion-sch1-chorus.php

If you want fast digital polyphonic octaves, there is a daisyseed program that will get you in the same latency territory as the...

I've built one and it behaves like a typical overdrive, and can get volume boost out.

Could use a clean with a toothbrush and isopropyl alcohol. I also was wondering with ErikS about that slashy looking line, and make...

Understood, but let's do the math. If the minimum gain of the noninverting opamp is 1+ R7/(R2||R4), then we have a minimum gain of 1+...

Lots of flux, hard to tell if there are solder balls/bridges causing shorts. I would clean the board to make sure there aren't any...

Some latency might actually be useful. Like when you record vocals and guitars, copy the recording and paste it a few thousandths of a...

I use a Slampegg Bee when recording bass and wanted something for guitar…enter C2CE. My first tube build, and it sounds amazing. I...

I used parts from Valvestorm, Mercury Magnetics, Tubesandmore.com, etc, based on freely available schematics and layouts online. The...

it's because of the way the feedback loop is set up. A fundamental function of an op amp is that it wants its pos and neg inputs to be...

I haven't done much tube rolling on that, I do have a Telefunken EF86 in my Nighthawk type amp and an ECC81, Russian EL84s and a...

I do have a scratch build matchless nighthawk style amp and an ac4 mashup that uses them.

What? No KT-88s? :LOL: