Rockman X100 Power Supply With MP1584EN DC-DC Buck Converter

Soloist Question
I have Followed the BC power supply instructions. Works great! HOWEVER, I am trying to use this BC power supply on a Rockman Soloist. The C1, C2, are obviously not the same as an X100. Does anyone know what mods I have to make to the Soloist to make the BC power supply work with the Soloist??
 
MNM1967 said:
Soloist Question
I have Followed the BC power supply instructions. Works great! HOWEVER, I am trying to use this BC power supply on a Rockman Soloist. The C1, C2, are obviously not the same as an X100. Does anyone know what mods I have to make to the Soloist to make the BC power supply work with the Soloist??
Click to expand...
Remove C203 & C204 on the Rockman Soloist to allow the dual MP1584EN supply to work . . . .

Screen Shot 2024-06-17 at 10.49.40 AM.png

Screen Shot 2024-06-17 at 10.50.46 AM.png
 
MNM1967 said:
Thank You SO much Cybercow!!!! Now I have to figure out why I have a ton of static..... But at least it powers up.
Click to expand...
Static? Have you replaced all the electrolytic caps? (Except C203 & C204.)
And the switches and jacks may need cleaning.
 
I have about 30 power supplies including several adjustable from 5 to 12 VDC capable of running + or - , even a couple powered breadboards. I should be able to put together a couple of these.
 
TheCleaner6969 said:
I have another X100 but it has the side TRS power jack. I just want to confirm with you that I can wire this power supply up to a male TRS 3.5mm using the +6v to "Tip" -6v to "Ring", & the Shield/Ground to the "Sleeve"?
Click to expand...
This is a interesting question because the original power adapter is regulated voltage and batteries are not,, my question is do you leave the 220 caps if you plug the modules in via TRS plug? Thanks if anyone answers and I apologize if this is considered hijacking a post.
 
Joeb said:
This is a interesting question because the original power adapter is regulated voltage and batteries are not,, my question is do you leave the 220 caps if you plug the modules in via TRS plug? Thanks if anyone answers and I apologize if this is considered hijacking a post.
Click to expand...
C1 & C2 (the 220µF caps on the X100 board) need to be removed when using the MP1584EN modules. Otherwise, they will appear as a load too heavy for the MP1584EN modules to boot.
 
TheCleaner6969 said:
I have another X100 but it has the side TRS power jack. I just want to confirm with you that I can wire this power supply up to a male TRS 3.5mm using the +6v to "Tip" -6v to "Ring", & the Shield/Ground to the "Sleeve"?
Click to expand...

Cybercow said:
C1 & C2 (the 220µF caps on the X100 board) need to be removed when using the MP1584EN modules. Otherwise, they will appear as a load too heavy for the MP1584EN modules to boot.
Click to expand...
Ok,, thanks for the reply
 
You must log in or register to reply here.
Back
Top